putting surface
英 [ˈpʊtɪŋ ˈsɜːfɪs]
美 [ˈpʊtɪŋ ˈsɜːrfɪs]
【体】推杆区
英英释义
noun
- an area of closely cropped grass surrounding the hole on a golf course
- the ball rolled across the green and into the bunker
双语例句
- Summarizing heat infrared anomaly evolution course of continental strong earthquakes, putting forward technical method for collecting the temperature field data inside and outside fault zones and earthquake surface temperature field data.
总结了大陆强地震的卫星热红外异常演化过程，提出了活动断裂带内、外温度和地表温度场提取的技术方法。 - Putting Shuangcheng Town as a study area, an improved coupling model was used to perform planning for water environment-economic system, with countermeasures of surface water environmentally sustainable development put forward.
将双城镇作为研究区域，利用改进后的耦合度模型进行水环境的环境-经济系统规划，并提出了地面水环境可持续发展的对策。 - New Technology of Putting Bronze-colored on Surface of Steel at Normal Temperature
钢铁表面常温古铜色处理新工艺 - The noise reduction methods are reducing the vibration for dynamic systems and putting sound-absorbing material in the shell surface.
对潜艇常用的降噪方法是给动力系统进行减振处理和在壳体表面贴吸声材料。 - You can test eggs by putting them in water; a good egg will sink while a bad egg will rise to the surface.
鸡蛋放入水中就可检验鸡蛋的好坏，好鸡蛋会沉入水底，而坏鸡蛋则会漂浮到水面上。 - By putting these animals on the surface, Hughes in this phase aims to give a biting satire on human beings 'corrupted world and to question the truth of the so-called anthropocentricism.
通过对这些动物形象的描写，休斯在这一阶段试图对人类日益衰败的世界进行强烈的讽刺，并对所谓的人类中心主义的真伪提出了质疑。 - The last phase of construction is parsing: putting the expressions relayed from the last phase into grammatical dependencies and arranging the latter in a linear format for the surface text.
建构的最后一个阶段必须是&分析（parsing）阶段，它会把连接起来的表达形式进一步作语法依存分析并以线性格式来表现为语篇。 - The MFT of image sensor is measured and calculated by putting rectangle template on the surface of image sensor and projecting rectangle template on the imaging sensor directly.
该方法将矩形模板紧贴于图像传感器，使矩形模板直接投射到图像传感器上，从而对图像传感器MTF进行测量。 - Consequently, putting inlet at the surface of medium and putting outlet at the middle-upper part of the medium is advised.
因此，建议将进水口置于湿地基质表层，而将出水口置于基质层的中上部。 - Methods The vibration isolation design was achieved by putting a set of T type rubber absorbers between the model and its mounted surface.
方法在模型与其连接面之间增加一组上下对接的T型橡胶减振器实现减振设计。